📞 +91-7667918914 | ✉️ iarjset@gmail.com
International Advanced Research Journal in Science, Engineering and Technology
International Advanced Research Journal in Science, Engineering and Technology A Monthly Peer-Reviewed Multidisciplinary Journal
ISSN Online 2393-8021ISSN Print 2394-1588Since 2014
IARJSET aligns to the suggestive parameters by the latest University Grants Commission (UGC) for peer-reviewed journals, committed to promoting research excellence, ethical publishing practices, and a global scholarly impact.
← Back to VOLUME 13, ISSUE 10, OCTOBER 2026

Design and Laboratory Evaluation of a Real- Time Onboard Load-Monitoring Prototype for Heavy-Truck Overload Prevention: Implications for Road and Environmental Sustainability in Tanzania

Gilbert M. Mollel, Dr. Nuru N. Kitara

👁 2 views📥 1 download
Share: 𝕏 f in ✈ ✉
Abstract: Heavy-truck overloading accelerates pavement deterioration, increases stress on vehicle components, complicates road-safety enforcement and may increase the life-cycle environmental burden of road freight through additional pavement rehabilitation, material consumption and vehicle emissions. This study designed and evaluated a laboratory prototype of an onboard system intended to provide drivers with continuous load information and an immediate overload warning. The prototype integrated a 500-kg S-beam strain-gauge load cell, an HX711 24-bit analogue-to-digital interface, an Arduino microcontroller, a liquid-crystal display, visual and audible alarms, and a SIM900 cellular module. A steel mounting concept was modelled for installation between a chassis cross-member and differential housing. Laboratory evaluation comprised sensor-output characterization (0–45 kg), calibration (0–100 kg), minimum-increment, hysteresis, repeatability and threshold-classification tests; dynamic and vibration behavior were assessed qualitatively. The reported sensor output increased from 0.000 to 0.900 mV over 0–45 kg, corresponding to a nominal sensitivity of 0.020 mV kg⁻¹. Across five non-zero calibration points, mean absolute percentage error was 0.226%, maximum absolute error was 0.18 kg and maximum percentage error was 0.30%. The maximum loading– unloading difference was 0.10 kg (0.10% of the 100-kg laboratory test span). Ten repeated applications of 50 kg produced a displayed value of 49.9 kg, indicating a −0.10 kg bias and no observable dispersion at the recorded 0.1-kg resolution. The alarm logic correctly classified all seven reported test points relative to a 100-kg laboratory threshold. These results demonstrate functional feasibility and good bench-scale agreement with reference masses. If validated at vehicle scale, preventive load information could support pavement preservation and more environmentally responsible freight management. However, the study did not measure pavement damage, fuel consumption, greenhouse-gas emissions, air pollutants, non-exhaust particle emissions or life-cycle impacts. Full-scale calibration against traceable axle-load references, controlled environmental and durability testing, uncertainty analysis, environmental-performance assessment and regulatory conformity evaluation are therefore required before field deployment.

Keywords: onboard weighing; truck overloading; load cell; axle-load monitoring; pavement sustainability; life-cycle assessment; freight emissions; laboratory validation; Tanzania

How to Cite:

[1] Gilbert M. Mollel, Dr. Nuru N. Kitara, “Design and Laboratory Evaluation of a Real- Time Onboard Load-Monitoring Prototype for Heavy-Truck Overload Prevention: Implications for Road and Environmental Sustainability in Tanzania,” International Advanced Research Journal in Science, Engineering and Technology (IARJSET), DOI: 10.17148/IARJSET.2026.131042

Creative Commons License This work is licensed under a Creative Commons Attribution 4.0 International License.