📞 +91-7667918914 | ✉️ iarjset@gmail.com
International Advanced Research Journal in Science, Engineering and Technology
International Advanced Research Journal in Science, Engineering and Technology A Monthly Peer-Reviewed Multidisciplinary Journal
ISSN Online 2393-8021ISSN Print 2394-1588Since 2014
IARJSET aligns to the suggestive parameters by the latest University Grants Commission (UGC) for peer-reviewed journals, committed to promoting research excellence, ethical publishing practices, and a global scholarly impact.
← Back to VOLUME 13, ISSUE 10, OCTOBER 2026

LMP-based Creep Rupture Estimate of an Alloy 617 Serpentine Superheater Tube Using Ansys

G. Aravindhan, P.P. Shantharaman

👁 1 view📥 0 downloads
Share: 𝕏 f in ✈ ✉
Abstract: Superheater tubes in ultra-supercritical power plants operate at high temperatures and pressures for prolonged periods, making creep rupture an important life-limiting mechanism. This study investigates the thermal-structural behaviour and estimates the creep-rupture life of an Alloy 617 serpentine superheater tube using finite element analysis and the Larson–Miller parameter method. The tube (OD 50.8 mm, ID 37.1 mm) carries steam at 700 °C and 300 bar and is heated externally by flue gas at 1500 K. The maximum wall temperature predicted by ANSYS is 733.84 °C. The computed temperatures agree with published straight-tube results within 0.5%. The inner-wall maximum principal stress of 96.08 MPa agrees with the Lamé thick-wall hoop stress of 98.6 MPa within 2.6%. Changing the mesh size from 4.5 mm to 5 mm alters the maximum stress by only 0.05%, although this does not establish mesh convergence. The bend peak von Mises stress reaches 143.47 MPa, approximately 1.3 times the straight-section inner-wall value of 108.65 MPa. The estimated rupture life is approximately 24,000 h without the standard-error correction and 6,600 h with it at the analytical hoop stress, decreasing to about 2,300 h at the bend peak stress. These estimates are below the 100,000 h design-life target discussed in the reference study. The findings highlight the influence of bend-induced stress concentration and stress selection on predicted rupture life. The results provide a preliminary estimate of creep-rupture life, and further validation is required.

Keywords: Alloy 617; superheater tube; Larson-Miller parameter; creep rupture; finite element analysis

How to Cite:

[1] G. Aravindhan, P.P. Shantharaman, “LMP-based Creep Rupture Estimate of an Alloy 617 Serpentine Superheater Tube Using Ansys,” International Advanced Research Journal in Science, Engineering and Technology (IARJSET), DOI: 10.17148/IARJSET.2026.131053

Creative Commons License This work is licensed under a Creative Commons Attribution 4.0 International License.